Drilling fiberglass can be a time consuming procedure if you wish to drill a perfect hole.
Can you drill holes in fiberglass doors.
This is because fiberglass has a gel coated surface and the edges of a drill bit tend to get underneath this surface and then chip it off.
Fiberglass is harder and stronger than wood but can just as easily be drilled into using wood drill bits.
Drilling holes in any hollow door is never a good idea.
Hanging curtains over a door s windows creates privacy and filters out light.
The holes are unattractive and can become a gateway for insects and moisture.
If you live in a rental and aren t permitted to drill into your doors or don t want to create a permanent fixture you can hang your curtains without drilling into the door.
Insert the barrel into the hole from the interior side and hand thread the viewer together.
Use the lowest speed possible to start the bit.
Once you make the holes and it doesn t work it will be difficult if not impossible to fill them in on a hollow door.
Then insert the lens into the hole from the exterior side of the door.
If you want to keep people from seeing in the glass part of your door you can buy products to put over the glass.
Filling holes in fiberglass doors requires a filler that is made for fiberglass components.
Patching compound and materials used to fill holes in wood doors do not work for fiberglass doors.
Slowly begin to drill a hole through the surface of the fiberglass.
If the barrel fits the hole too tightly to rotate remove it from the hole.
Once the holes are filled you may stain or paint the doors.
Put the drill bit back into the hole and run it for a few seconds to clean it up and enlarge it very slightly.
As it begins to dig into the fiberglass increase the rotational speed.
Drill halfway into the door from one side using the pilot hole you drilled earlier as a.
However drilling to install hardware damages the door.
You can decorate fiberglass doors with blinds or other accessories that require screw holes for mounting.